A local, experimental, high performance and robust data backbone.
Goals
* greater than 100 Mb/s performance.
* robust loss of any one node will on
* optional and controllable - passing OLSRD mesh routing info transparently. Learn how to do this.
Measuring
* network monitoring such as MRTG or CACTI
* examples -
Technologies
* Mikrotik radios, 5 GHz, NV2 data
* N or AC mode for user access - ideally both 2.4 and 5 GHz.
Do Next:
- Access the nodes
- Better plan
- Get two nodes linked
Equipment Acquired or otherwise allocated to project
* 6/26 - Fired up Mikrotik radio for the first time. One of the RB-SXT units. Set laptop to static IP 192.168.88.20 and it browsed to 192.168.88.1 - Very rich tool set. Now for a better plan of how to design the system.
* 6/23/2014 - Have RB-SXT radios. Three DIR-825 for the node switch and access. Time to power up.
* 6/17/2014 - ordered 2 Mikrotik RB-SXT 5 GHz radios from FAB Corp.
* x/x/2014 - 14xNn $80 Mikrotik Groove from XX
* x/x/2014 - 14xNn $95 Mikrotik 5SHPn 14xNN1 from XX
* 4/18/2014 - 14d41 $46 ECHO58 Echo Series 5.3GHz - 5.8GHz 17 dBi Backfire Antenna from FAB Corp
* 4/14/2014 - 14d42 $54 patch58-19 Tri-Band 5.3GHz - 5.8GHz 19dBi Flat Panel Antenna from FAB Corp
Notes
* Complete system will have two full service nodes each linked to two Link nodes
* The services and data on each of the servers will be identica.
* A third server will be running 'at home' to provide hot backup and development
* Full Service Node - all provide the same services with mirrored data
* Running on UPS
* Full size external hard disk of at least 1T
* User Access
* Two Backbone Radios
* Server -
* IRC
* Asterix
* Link Node
* User Access - one switch with gigabit Ethernet and dual radios on 2.4 GHz and 5 GHz
* Two backbone radios
* DC power - probably 12V
Mikrotik Notes
Q: Dean - If you add lines to a list (say, the "/ip firewall filter" list), they are added at the end. Then, you can "print" where they are in the list, and "move" them to where you want them. You can't directly insert, but that's OK. Where the idiosyncrasy comes is, if you save what you did, and later paste it into the command line (without including the "print" command), it won't work. Apparently the numbering of the lines (needed for the "move" command) doesn't occur until you do a "print".
A: Nigel - You can indeed place them where you like, using 'place-before=NUM' in your add command, and yes, numbering is dependent on you having performed a
HamWAN Notes
Tom/LXL - With the SNMP stuff I've been playing with for MRTG/Cacti - it's just a read only port. If so, maybe Dean would open that up for you.
It should be enough to complete the snmp section of the client node configuration instructions:
/snmp set enabled=yes contact="#HamWAN on irc.freenode.org"
/snmp community set name=hamwan addresses=44.24.255.0/25 read-access=yes write-access=no numbers=0
